1st shift M-F 7am-3:30pm Wage- $20.00-$24.00hr DOE No Background check or Drug Test required Must Be a US Citizen Job Summary: To add components, wires, epoxy, hardware, and modifications to circuit boards and assemble circuit boards into final assemblies per customer requirements. Duties/Responsibilities Must read and understand technical documents such as customer blueprints, standard operating procedures, and other related documents. Add components, wires, epoxy, and hardware to circuit boards using equipment and tools as required such as tweezers, pliers, cutters, solder iron, magnifying light and/or microscope. Hand wash areas of the board where sensitive components have been hand soldered. Add modifications called out in documents to ensure the board is built to the revision stated in the job folder. Install circuit board into final assembly if required by the job folder. Maintain daily times worked on specific jobs by scanning in/out of computer and/or keeping daily timesheets when requested. Performs other record keeping as required by department. Work independently while maintaining high quality and concentration. Perform the same steps repeatedly throughout the day with minimal errors. Contributes to maintaining a safe work environment by following safety policies and procedures, reporting any safety concerns, and participating in any scheduled stretch breaks. Actively participates in quality efforts and support the Company Quality Policy through accountable action. Responsible for compliance to the Company Quality Management System and other regulatory and statutory requirements as required by the customer. Act as an authorized agent to stop production when nonconformances are noted. Accountable for accepting responsibility for continuous on the job training by actively participating in training put on by designated Company employees and/or any outside service. Education and Experience: High school diploma or general education degree (GED), or 3-6 months related work experience. Soldering experience, IPC or JSTD certification, and/or electronics assembly experience preferred. Basic PC skills. Experience with Microscope SMT parts and small gauge wiring.